Dtpvc Setup Slot Screen - ZyXEL Communications MSC1000G User Manual

Chapter 9 Subscriber Port Setup Screens
Table 139 DTPVC Setup (continued)
LABEL
Cancel
ID
State
Card Type
Up Time
Firmware

9.29.1 DTPVC Setup Slot Screen

Click Port > DTPVC in the navigation panel to open the DTPVC Setup screen. Click an active
ADSL or SHDSL line card's ID number to open the following screen. Use this screen to view and
delete DTPVCs from the line card's DSL ports.
Figure 198 DTPVC Setup: Slot
The following table describes the fields in this screen.
Table 140 DTPVC Setup: Slot
LABEL
UP
Delete
Index
Port
VPI/VCI
Profile
MUX
Type
SVID
304
DESCRIPTION
Click Cancel to begin configuring the screen again.
This column lists the slot numbers of the line cards. Click the ID number of an active DSL line
card to go to a screen where you can view and delete PVCs from the line card's DSL ports.
This field displays the line card's current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could be due to
the card starting, a firmware upgrade in progress or a malfunction. See
1111 for what to do if the line card stays stuck in the inactive state.
This field displays the type of a line card.
This field displays how long the line card has been running since the last time it was started.
This field displays the current firmware version installed on the line card.
DESCRIPTION
Click this to return to the previous screen.
Click Delete to remove the selected DTPVC(s).
This is the number of the DTPVC.
This is the number of a DSL port on the line card.
This field displays the Virtual Path Identifier (VPI) and Virtual Circuit Identifier (VCI). The VPI
and VCI identify a channel on this port.
This field displays the ATM profile that this channel uses.
This field displays the encapsulation type (llc or vc) for this channel.
This field shows that the channel is a DTPVC (dtag).
This is the service provider's VLAN ID (the outer VLAN tag) that the line card assigns to
untagged frames received on this channel.
Section 38.7 on page
Management Switch Card User's Guide