Queue Rate Limit Profile Setup Screen - ZyXEL Communications MSC1000G User Manual

11.27 Queue Rate Limit Profile Setup Screen

Click Profile > Queue Rate Limit to open this screen. Use this screen to configure VDSL2 and
Ethernet subscriber line per-queue rate limit profiles. Apply the rate limit profiles to individual
VDSL2 and Ethernet line card ports (see
Figure 269 Profile > Queue Rate Limit
The following table describes the labels in this screen.
Table 189 Profile > Queue Rate Limit
LABEL
Name
Queue
CIR
PIR
Apply
New
Cancel
Index
Management Switch Card User's Guide
Section 9.9 on page 244
DESCRIPTION
Enter a descriptive name for the queue rate limit profile. The name can be 1-31 printable
ASCII characters long. Spaces are not allowed.
These are the Class of Service (CoS) queues.
CIR is Committed Information Rate. Enter the maximum data rate (0~100032 kbps)
guaranteed to flow through this queue. It must be a multiple of 64. See
page 385 for more information.
Note: CIR should be less than or equal to PIR.
PIR is Peak Information Rate. Enter the maximum data rate (0~100032 kbps) allowed to
flow through this queue. It must be a multiple of 64. See
more information.
Click Apply to save the changes in this screen to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile
memory when you are done configuring.
While you are modifying a profile, you can click New to start configuring a fresh profile
without saving your changes.
Click Cancel to start configuring the screen again.
This is an incremental number indicating the order in which the profiles were created.
Chapter 11 Profile Screens
and Section 9.28 on page
Section 11.23 on
Section 11.23 on page 385
295).
for
407