ZyXEL Communications MSC1000G User Manual page 373

Figure 239 IGMP Filter Profile
The following table describes the fields in this screen.
Table 176 IGMP Filter Profile
LABEL DESCRIPTION
Name Type a name to identify the IGMP filter profile (you cannot change the name of the DEFVAL
profile). You can use up to 31 English keyboard characters; spaces are not allowed.
Start IP Enter the starting multicast IP address for a range of multicast IP addresses to which you want this
IGMP filter profile to allow access.
End IP Enter the ending multicast IP address for a range of IP addresses to which you want this IGMP filter
profile to allow access.If you want to add a single multicast IP address, enter it in both the Start
IP and End IP fields.
Apply Click Apply to save the changes in this screen to the system's volatile memory. The system loses
these changes if it is turned off or loses power, so use the Config Save link on the navigation
panel and then the Save button to save your changes to the non-volatile memory when you are
done configuring.
New While you are modifying a profile, you can click New to start configuring a fresh profile without
saving your changes.
Cancel Click Cancel to start configuring the screen again.
Index This is the index number of the IGMP profile.
Name This is the name of the IGMP profile.
Management Switch Card User's Guide
Chapter 11 Profile Screens
373