The H.248 Port Setup Line Card Screen - ZyXEL Communications MSC1000G User Manual

9.26 The H.248 Port Setup Line Card Screen

Use this screen to see and edit the current VoIP configuration of each port on a H.248 VoIP line
card. Click a line card's ID number in the Port > VoIP H248 screen. The following screen displays.
Figure 188 The Port > VoIP H248 Setup > H248 Port Setup Line Card Screen
The following table describes the labels in this screen.
Table 133 Port > VoIP H248 Setup > H248 Port Setup Line Card Screen
LABEL
UP
Copy
Apply
Cancel
Management Switch Card User's Guide
DESCRIPTION
Click this to return to the Port > VoIP H248 screen.
Use this to assign the selected port's settings to other ports.
1. Click Copy. The following pop-up screen displays.
Figure 189 Copy Port Settings
2. Select the required slot from the drop-down list.
3. Select the port(s) to which you want to copy the settings. Use Select All to select every
port. Use Select None to clear all of the check boxes.
4. Click Apply to copy the settings, or click Cancel to close the window without saving any
changes.
Click this to save your changes to the MSC's volatile memory. The MSC loses these changes if
it is turned off or loses power, so use the Config Save link on the navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click this to begin configuring the fields again.
Chapter 9 Subscriber Port Setup Screens
293