The Sip Port Setup Line Card Screen - ZyXEL Communications MSC1000G User Manual

Chapter 9 Subscriber Port Setup Screens
Table 129 Port > VoIP SIP Setup Screen
LABEL
Copy
ID
State
Card Type
Up Time
Firmware

9.23 The SIP Port Setup Line Card Screen

Use this screen to see and edit the current VoIP configuration of each port on a SIP VoIP line card.
Click a line card's ID number in the Port > VoIP SIP screen. The following screen displays.
286
DESCRIPTION
Use this to assign a port's settings to other ports.
1. Click Copy. The following pop-up screen displays.
Figure 182 Copy Port Settings
2. Select the required slot from the drop-down list.
3. Select the port(s) to which you want to copy the settings. Use Select All to select
every port. Use Select None to clear all of the check boxes.
4. Click Apply to copy the settings, or click Cancel to close the window without
saving any changes.
This column displays the line card's slot number. Click a SIP line card's number to go
to the card's SIP Port Setup Line Card screen (see
where you can see and edit all a SIP line card's VoIP configuration in a single screen.
This displays Active if the line card is enabled, or - if a line card is not enabled.
This displays a line card's model name.
This field displays how long the line card has been running since it was started up.
This field displays the current firmware version installed on the line card.
Section 9.23 on page
Management Switch Card User's Guide
286)