Igmp History Screen - ZyXEL Communications MSC1000G User Manual

Chapter 8 Multicast Screens
Table 77 Multicast > IGMP > Bandwidth (continued)
LABEL
Start Mcast Ip
End Mcast Ip
Bandwidth
Apply
New
Cancel
Index
Start Mcast Ip
End Mcast Ip
Bandwidth
Modify
Delete

8.4 IGMP History Screen

Click Multicast > IGMP History in the navigation panel to display the screen shown next.
Use this screen to enable/disable IGMP historical data collection. You can also flush all IGMP
historical data on this screen.
Note: This screen only supports the VLC13xx line cards.
192
DESCRIPTION
Enter the starting IP address in the range of multicast IP addresses to which the bandwidth
setting applies. Use an IPv4 address in dotted decimal notation or an IPv6 address and
prefix in colon hexadecimal notation.
Enter the ending IP address in the range of multicast IP addresses to which the bandwidth
setting applies. Use an IPv4 address in dotted decimal notation or an IPv6 address and
prefix in colon hexadecimal notation.
Select Enable to enable bandwidth control and type a maximum bandwidth (in kbps)
allowed for the traffic flow on a port.
Click Apply to save the changes in this screen to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile
memory when you are done configuring.
After you click Apply, entries display in the first table so you can edit them. Click New if
you want to configure a different static multicast group.
Click Cancel to begin configuring the screen again.
This displays the index number of records in the multicast group bandwidth control table.
This displays the start IP address in the range of multicast IP addresses to which the
bandwidth settings applies.
This displays the end IP address in the range of multicast IP addresses to which the
bandwidth settings applies.
This displays specified the bandwidth applied to the multicast hosts.
Select a multicast group's radio button and click Modify to display the multicast group in
the table above so you can edit it.
Select a multicast group's radio button and click Delete to remove the multicast group.
Management Switch Card User's Guide