Chapter 7 Maintenance Screens
Figure 101 Configuration Restore
Type the path and file name of the configuration file you wish to restore in the File Path text box or
click Browse to display a Choose File screen from which you can locate it. After you have
specified the file, click Restore. "conf-0" is the name of the configuration file on the system, so
your backup configuration file is automatically renamed when you restore using this screen.
7.3 Configuration Reset Screen
Click Maintenance > Config Reset in the navigation panel to open the following screen. Use this
screen to clear all system configuration information that you have configured and return to the
factory defaults.
Figure 102 Configuration Reset
Click Reset to return the system to the factory default settings.
Figure 103 Confirm Restore Factory Default Settings
Click OK to begin resetting all system configurations to the factory defaults and then wait for the
system to restart. This takes up to two minutes. If you want to access the Web Configurator again,
you may need to change the IP address of your computer to be in the same subnet as that of the
default system IP address (192.168.1.1 for in-band, 192.168.0.1 for out-of-band).
180
Management Switch Card User's Guide