Enet Vlan Setup - ZyXEL Communications MSC1000G User Manual

Table 136 ENET Port Setup: Line Card (continued)
LABEL
Customer
Information
Rate Limit Profile
Select

9.28.2 ENET VLAN Setup

Click Port > ENET in the navigation panel to open the ENET Port Setup screen. Select an
Ethernet line card ID, a port index number and click Setup next to VLAN to open the following
screen. Use this screen to add the port to VLANs (or remove it from VLANs) and configure the TLS
(Transparent LAN Service) settings.
Figure 195 ENET VLAN Setup
The following table describes the fields in this screen.
Table 137 ENET Port Setup: VLAN Setup
LABEL
UP
PVID /
Priority
TLS Enable
Management Switch Card User's Guide
DESCRIPTION
Enter information to identify the subscriber connected to this port. You can use up to 31
printable English keyboard characters (including spaces and hyphens).
Select a profile of maximum egress and ingress rate settings.
Use the Select column to choose a port from which you want to copy settings.
DESCRIPTION
Click this to return to the previous screen.
Specify the port VLAN ID (1~4094) and IEEE 802.1p priority (0~7) to add to untagged frames
received on this port. "0" is the lowest priority level and "7" is the highest. When you enable
TLS, the system does not apply this PVID.
Transparent LAN Service (also known as VLAN stacking or Q-in-Q) allows a service provider to
distinguish multiple customers VLANs, even those with the same (customer-assigned) VLAN
ID, within its network.
Once you enable TLS, all packets will be added an extra "VLAN tag" (SPVID/Priority) and
forwarded toward Gigabit Ethernet interface(s).
Select this option to enable TLS. Clear this check box to disable it. See
824 for more information on TLS.
The system does not apply the port VID (PVID) when you enable TLS.
Chapter 9 Subscriber Port Setup Screens
Section 29.40 on page
299