Ipbpvc By Slot Screen - ZyXEL Communications MSC1000G User Manual

Chapter 9 Subscriber Port Setup Screens
Figure 175 IPBPVC: VLAN Setup
The following table describes the labels in this screen.
Table 125 IPBPVC: VLAN Setup
LABEL
UP
VPI/VCI
VID
Registration
Tag
Apply
Cancel
Index
VPI/VCI
VID
Registration
Tag
Select
Modify
Delete

9.19.2 IPBPVC by Slot Screen

This screen displays all of the IPB PVCs on a particular line card.
276
DESCRIPTION
Click UP to go back to the previous screen.
This field displays the Virtual Path Identifier (VPI) and Virtual Circuit Identifier (VCI). The VPI
and VCI identify a IPB PVC (a channel).
Type the VLAN ID to which this channel belongs. This VLAN ID must be in an IP bridge domain.
Select join to have the port be a member of the specified VLAN.
Select leave to remove the port from the specified VLAN.
Select the check box to tag all frames transmitted on this PVC with the port's VID.
Click Apply to save changes on the selected IPB PVC.
Clicking Apply saves your changes to the MSC's volatile memory. The MSC loses these
changes if it is turned off or loses power, so use the Config Save link on the navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to start configuring the screen again.
This field displays the index number of a IPB PVC on this port.
This field displays the Virtual Path Identifier (VPI) and Virtual Circuit Identifier (VCI). The VPI
and VCI identify a IPB PVC (a channel).
This is the VLAN ID to which this channel belongs.
This field displays fixed to indicate that the port is a member of the specified VLAN.
This field displays V if the line card is to tag all frames that are transmitted out on this PVC
with this VLAN group ID. It displays - if the line card does not tag all frames that are
transmitted out on this PVC with this VLAN group ID.
Select the radio button in the Select column for an entry and click Modify to be able to edit
the entry, or Delete to remove the entry.
Select the radio button in the Select column for an entry and click Modify to be able to edit
the entry.
Select the radio button in the Select column for an entry and click Delete to remove the
entry.
Management Switch Card User's Guide