Pvc Setup Vlan Screen - ZyXEL Communications MSC1000G User Manual

Chapter 9 Subscriber Port Setup Screens
Table 115 PVC Setup: Slot (continued)
LABEL DESCRIPTION
Priority This field displays the priority value (0 to 7) that the line card adds to frames that come in on this
PVC without a (IEEE 802.1p) priority tag.
Select Select one or more PVCs' check boxes and then use the Delete button to remove it (or them).
Use the Select All check box to select all of the PVCs for all of the line card's ports.

9.12.2 PVC Setup VLAN Screen

Click Port > PVC in the navigation panel to open the PVC Setup screen. Click an active ADSL or
SHDSL card ID and a PVC's index number to open the following screen. Use this screen to add the
PVC to more VLANs (or remove it from VLANs). You can also get to this screen by clicking a PVC's
index number in the PVC Setup Slot screen.
Figure 164 PVC Setup: VLAN
The following table describes the fields in this screen.
Table 116 PVC Setup: VLAN
LABEL
UP
VPI/VCI
VID
Registration
Tag
Apply
Cancel
260
DESCRIPTION
Click this to return to the previous screen.
This field displays the Virtual Path Identifier (VPI) and Virtual Circuit Identifier (VCI). The VPI
and VCI identify the channel.
Type a VID (VLAN ID) to add this channel as a member.
This must be the VLAN ID of a VLAN that is already configured. The port that you are
configuring must also be set to the fixed status in the VLAN.
Select join to have the port be a member of the specified VLAN.
Select leave to remove the port from the specified VLAN.
Select the check box to tag all frames that are transmitted out on this PVC with this VLAN
group ID.
Click Apply to save the changes in this screen to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile memory
when you are done configuring.
Click Cancel to begin configuring the screen again.
Management Switch Card User's Guide