ZyXEL Communications MSC1000G User Manual page 765

Table 364 port Commands (continued)
COMMAND
set
show
usratelimit
vlan
xvlan
show
shdsl alarmprof
Management Switch Card User's Guide
<slot-port-vpi/vci>
<profile> <mux>
<pvid> <priority>
[acname <acname>]
[srvcname <srvcname>]
[hellotime
<hellotime>]
<slot>|<slot-
port>|<slot-port-
vpi/vci> [detail]
enable <slot-port-
vpi/vci>
disable <slot-port-
vpi/vci>
set <slot-port-vpi/
vci> <rate>
show <slot>|<slot-
port>|<slot-port-
vpi/vci>
<slot-port-vpi/vci>
<vid> <registration>
<tag>
delete <slot-port-
vpi/vci> <cvid>
set <slot-port-vpi/
vci> <cvid> <svid>
<slot-port-vpi/vci>
<slot-port>
span|stuc|stur|*
<alarmprofile>
DESCRIPTION
Creates or modifies a PVC setting.
profile: The asynchronous transfer mode (ATM)
profile. Specify the ATM profile using profile atm
commands.
acname: The hostname of a remote access concen-
trator. You can use 1-31 printable ASCII charac-
ters. Spaces are allowed.
srvcname: The name of the service that uses this
PVC. You can use 1-31 printable ASCII characters.
Spaces are allowed.
hellotime: The timeout (0~600 in seconds) for
the PPPoE session. Enter 0 if there is no timeout.
Note: Use these ,
acname srvcname
settings for the ALC1372G-51 only.
Displays runtime configured virtual channels.
Activates upstream rate limiting on the specified
PVC.
Deactivates upstream rate limiting on the specified
PVC.
Sets the maximum upstream rate (in Kbps) the
specified PVC is allowed to use.
Displays upstream rate limiting settings for the
specified slots, ports, or PVCs.
Adds a PVC channel to a VLAN.
Removes the specified XVLAN entry (cvid) from the
specified PVC channel.
Creates an XVLAN entry for the specified PVC
channel. cvid is the original customer VLAN ID.
When the port receives traffic from the subscriber
with a cvid VLAN tag, XVLAN changes it to the
svid before forwarding it to the service provider's
network.
Displays the XVLAN settings for the specified PVC
channel.
Sets SHDSL ports or end point(s) to use an alarm
profile.
: set alarm profile for the whole span
span
: set alarm profile at stuc end point
stuc
: set alarm profile at stur end point
stur
: set alarm profile at both stuc and stur
*
Chapter 29 port Commands
P
8
, and
hellotime
1
8
8
8
1
8
8
8
1
8
765