ZyXEL Communications MSC1000G User Manual page 542

Chapter 13 Switch Screens
Figure 374 CFM Endpoint: MEP
The following table describes the labels in this screen.
Table 288 CFM Endpoint: MEP
LABEL
MD Name
MA Name
Endpoint ID
Port
Direction
Priority
CCI-enabled
Alarm Time
Reset Time
MAC Address
Apply
New
Cancel
Index
MEP ID
542
DESCRIPTION
This displays the name of the MD for which you want to configure end points.
This displays the name of the MA for which you want to configure end points.
Select a valid MEP ID which is defined in the CFM maintenance association screen.
This binds the MEP ID to a physical port on the device. You can select an Ethernet port
(enet1 or enet2) or select a DSL port (by specifying a slot number and port number of a
line card).
Select whether to send CCMs (Connectivity Check Messages) from the end point you
selected in this screen (when you select down) or from (s) (when you select up). Select
up only when the link of the specified end point is down.
Select the priority level for the CCMs configured in this screen. "0" is the lowest priority
level and "7" is the highest.
Select this to enable CCMs sending from the end point configured in this screen. Deselect
this to stop CCMs sending.
This is the number of seconds the MSC waits to send a local alarm after three
CFM_ERROR events have been detected.
This is the number of seconds the MSC waits to cancel a local alarm after a CFM_ERROR
event has been resolved and no other alarms that have occurred.
Enter the CFM end point's MAC address.
Click Apply to add the settings as a new entry in the summary table above.
Click New to start configuring an MA setting.
Click Cancel to reset the fields.
This field displays the index number of an end point.
This field displays the MEP ID of the end point used when you need to do a CFM test or
view the CFM statistics.
Management Switch Card User's Guide