Vdsl2 Port Setup - ZyXEL Communications MSC1000G User Manual

Chapter 9 Subscriber Port Setup Screens
The following table describes the fields in this screen.
Table 108 VDSL Port Setup: Xvlan Setup: Slot
LABEL
UP
Delete
Index
Port
Cvid
Svid
Cvid-S
Select
Select All

9.9 VDSL2 Port Setup

Click Port > VDSL2 in the navigation panel to open the following screen. Use this screen to
configure settings for individual VDSL ports on VLCs that follow the VDSL2 MIB (defined in draft-
ietf-adslmib-vdsl2-06).
244
DESCRIPTION
Click this to return to the previous screen.
Select one or more entries' Select radio buttons and then click Delete to remove them.
This is the number of an XVLAN entry on this port.
This is the number of a DSL port on the line card.
This is the original customer VLAN ID. When the port receives traffic from the subscriber with
this VID, it applies this XVLAN entry's settings before forwarding it to the service provider's
network.
Note: For ports with XVLAN entries, the system drops tagged traffic from the subscriber that does
not match an XVLAN entry.
To forward untagged traffic from a subscriber port that has XVLAN entries, configure an XVLAN
entry with the port's PVID as the Cvid. The system assigns the port's PVID to untagged packets
from the subscriber and then checks against the port's XVLAN entries.
This is the service provider VLAN ID for use on the service provider's network.
This applies to the VLC13XXG cards. This is the translated customer VLAN ID for use on the
service provider's network.
Select an entry's Select check box and click Delete to remove the entry.
Clicking Delete saves your changes to the MSC's volatile memory.
The MSC loses these changes if it is turned off or loses power, so use the Config Save link on
the navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Select this check box to select all of the column's check boxes. Clear this check box to clear all of
the column's check boxes.
Management Switch Card User's Guide