Switch Cfm Screens - ZyXEL Communications MSC1000G User Manual

13.19 Switch CFM Screens

Click Switch > CFM in the navigation panel to display the screen shown next. Use this screen for
initial configuration of a CFM (Connectivity Fault Management) domain, to globally switch this
feature on or off and to create an MD. Refer to
Figure 372 Switch CFM
The following table describes the labels in this screen.
Table 286 CFM Maintenance Domain
LABEL
CFM Enable
CFM Mode
MIP responds to
mlbms enable
MD Name
Level
Apply
New
Cancel
Index
MD Name
Level
No. of ma
Modify
Delete
Management Switch Card User's Guide
DESCRIPTION
Select or deselect the check box and click Apply to turn the CFM feature on or off.
Select whether CFM uses IEEE 802.1ag or the ITU-T Recommendation Y.1731 which also
deals with performance management.
When the CFM Mode is set to 802.1ag, you can select this option to have MIP respond
to mLBM messages. mLBM messages employ unique broadcast destination addresses
that are incompatible with link state Ethernet protocol and will result in loops.
Type a name (up to 31 printable ASCII characters) for this MD. This is for identification
purposes.
Type a level number (0~7) for this MD.
Click Add to add the settings as a new entry in the summary table below.
Click New to start configuring the MD setting again.
Click Cancel to reset the fields.
This field displays the index number for the record in this summary table. Click an index
number to configure the associated MA under this MD.
This field displays the descriptive name of the MD.
This field displays the level number of the MD.
This field displays the number of the MAs under this MD.
Select an MD and click Modify to bring the MD information in this screen for modification.
Select an MD and click Delete to remove an MD.
Section 6.1 on page 163
Chapter 13 Switch Screens
for more information.
539