Dscp Port Screen - ZyXEL Communications MSC1000G User Manual

Chapter 4 Access Control List Screens
Figure 54 ACL > DSCP > Setup
The following table describes the labels in this screen.
Table 37 ACL > DSCP > Setup
LABEL
DSCP mapping
(priority)
Apply
Cancel

4.18.2 DSCP Port Screen

Click ACL > DSCP > Port to display the screen shown next. Use this screen to enable or disable
the mapping between DSCP code points and IEEE 802.1p priorities for VLC1324G, VLC1348G, ELC,
or GLC subscriber ports.
118
DESCRIPTION
Use the drop-down list boxes to select an IEEE 802.1p priority to which the Device should
change the DSCP service level.
For example, to find the IEEE 802.1p priority level for DSCP service level 43, find 40 in the
left hand column and 3 in the top row. The intersection of the 3 column and 40 row shows a
priority setting of 5.
Click Apply to save the changes in this screen to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile memory
when you are done configuring.
Click Cancel to begin configuring the screen again.
Management Switch Card User's Guide