11.7.1 VDSL2 Line Profile Setup
Click Profile > VDSL2 and click the LineProfile link to open the screen as shown next. Use the
screen to add, edit or delete a VDSL2 line profile.
Figure 220 Profile > VDSL2 > LineProfile
The following table describes the labels in this screen.
Table 160 Profile > VDSL2 > LineProfile
LABEL
Name
VDSL2 Profile
Max SNR Margin
Target SNR Margin
Min SNR Margin
Management Switch Card User's Guide
DESCRIPTION
Enter a descriptive name for identification purposes.
Specify the VDSL2 profile(s) you want to apply to this line profile. See
page 206
for more information.
Enter the maximum SNR (Signal to Noise Ratio) margin allowed on the line. When the
actual SNR margin is going to reach this specified value, this mechanism forces
connected CPE device(s) to lower its transmission power level and maintains the actual
SNR margin equal to or less than this value. Select noLimit to turn this mechanism off.
Enter the target downstream and upstream SNR (Signal to Noise Ratio) margin.
Enter the minimum downstream and upstream SNR margin accepted on the line to
which this profile applies.
Chapter 11 Profile Screens
Section 9.2.4 on
341