Switch Port Setup Bandwidth Screen - ZyXEL Communications MSC1000G User Manual

Chapter 13 Switch Screens

13.16 Switch Port Setup Bandwidth Screen

Click Switch > Switch Port Setup > Bandwidth in the navigation panel to display the screen
shown next. Use this screen to configure bandwidth control settings for the Gigabit Ethernet
interfaces.
Figure 369 Switch Port Setup: Bandwidth
The following table describes the labels in this screen.
Table 283 Switch Port Setup: Bandwidth
LABEL
Port
Enable
Ingress Rate
Egress Rate
Apply
Cancel
13.17 Switch Port Setup Broadcast Screen
Click Switch > Switch Port Setup > Broadcast in the navigation panel to display the screen
shown next. Use this screen to configure broadcast storm control settings for the Gigabit Ethernet
interfaces.
536
DESCRIPTION
This is the label of a Gigabit Ethernet interface.
Select this check box to turn on bandwidth control for an interface.
Type a maximum bandwidth allowed for the incoming traffic flow on a port (measured in
megabits per second). Use a number from 0 to 1000.
Type a maximum bandwidth allowed for the out-going traffic flow on a port (measured in
megabits per second). Use a number from 0 to 1000.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save link
on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Management Switch Card User's Guide