Switch Port Gvrp Commands - ZyXEL Communications MSC1000G User Manual

33.14.6 switch port gvrp Commands

Use the
switch port gvrp
interfaces.
33.14.6.1 switch port gvrp disable Command
Syntax:
switch port gvrp disable <giga-port>
This command turns off GVRP on a Gigabit Ethernet interface.
GVRP (GARP VLAN Registration Protocol) is a registration protocol that defines a way for switches to
register necessary VLAN members on ports across the network. Disable GVRP to have the system
not propagate VLAN information to other devices.
The following example turns off GVRP on the subtending 1 Gigabit Ethernet interface.
ras> switch port gvrp disable sub1
33.14.6.2 switch port gvrp enable Command
Syntax:
switch port gvrp enable <giga-port>
This command turns on GVRP on a Gigabit Ethernet interface.
GVRP (GARP VLAN Registration Protocol) is a registration protocol that defines a way for switches to
register necessary VLAN members on ports across the network. The system propagates VLAN
information to other devices when you enable GVRP.
The following example turns on GVRP on the subtending 1 Gigabit Ethernet interface.
ras> switch port gvrp enable sub1
33.14.7 switch port mode Command
Syntax:
switch port mode sub1|sub2|up1|up2 <uplink|subtend>
This command sets a Gigabit Ethernet interface to function as uplink or subtending.
The following example sets the subtending 1 Gigabit Ethernet interface to uplink mode.
ras> switch port mode sub1 uplink
Management Switch Card User's Guide
commands to configure GVRP settings for the Gigabit Ethernet
Chapter 33 switch Commands
1023