Enet Dot3Ad Setup - ZyXEL Communications MSC1000G User Manual

Chapter 9 Subscriber Port Setup Screens
Table 137 ENET Port Setup: VLAN Setup (continued)
LABEL
TLS SVID /
SPriority
Apply
Cancel
VID
Registration
Tag
Apply
Cancel
The table in the bottom half of the screen lists the VLANs that the port is a member of.
Modify
Delete
Index
VID
Registration
Tag
Select

9.28.3 ENET Dot3ad Setup

Click Port > ENET in the navigation panel to open the ENET Port Setup screen. Select an
Ethernet line card ID, a port index number and click Setup next to Dot3ad to open the following
screen. Use this screen to configure the Ethernet line card's IEEE 802.3ad link aggregation settings.
See Section 13.2 on page 513
300
DESCRIPTION
This is the service provider's VLAN ID (the outer VLAN tag). In the first field, enter the service
provider ID (from 1 to 4094) for frames received on this port.
In the second field, enter the priority level for the service provider's VLAN ID. "0" is the lowest
priority level and "7" is the highest.
Click Apply to save the changes in this screen to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile memory
when you are done configuring.
Click Cancel to begin configuring the screen again.
Type a VID (VLAN ID) to add this port as a member.
This must be the VLAN ID of a VLAN that is already configured. The port that you are
configuring must also be set to the fixed status in the VLAN.
Select join to have the port be a member of the specified VLAN.
Select leave to remove the port from the specified VLAN.
Select the check box to tag all frames transmitted on this port with the port's VID.
Click Apply to save the changes in this screen to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile memory
when you are done configuring.
Click Cancel to begin configuring the screen again.
Click Modify to display the selected VLAN membership entry's settings in the fields above so
you can edit them.
Click Delete to remove the selected VLAN membership entry.
This is the number of the VLAN membership entry.
This field displays the number of a VLAN (VLAN ID) of which this port is a member.
This field displays "fixed" to indicate that the port is a member of the specified VLAN.
This field displays "V" if the line card is to tag all frames that are transmitted out on this port
with this VLAN group ID. It displays "-" if the line card does not tag all frames that are
transmitted out on this port with this VLAN group ID.
Select the radio button of a VLAN membership entry and then use the Modify button or the
Delete button.
for more on IEEE 802.3ad link aggregation.
Management Switch Card User's Guide