Switch Setup Qschedule Screen - ZyXEL Communications MSC1000G User Manual

Chapter 13 Switch Screens

13.7 Switch Setup QSchedule Screen

Click Switch > Switch Setup > QSchedule to display the screen as shown.
Figure 352 Switch Setup QSchedule
The following table describes the labels in this screen.
Table 272 Switch Setup QSchedule
LABEL
Port
Algo_Type
Queue 0~7
Apply
Cancel
13.8 Switch Setup Isolation Screen
Click Switch > Switch Setup > Isolation to display the screen as shown.
518
DESCRIPTION
This column lists the management switch card's Gigabit Ethernet interfaces.
Use this field to set a Gigabit Ethernet interface's queuing algorithm. If trunking is enabled,
you set this for one interface and it applies to the whole trunk group.
Select spq to use Strict Priority Queuing (SPQ). SPQ services queues based on priority only.
When the highest priority queue empties, traffic on the next highest-priority queue begins.
Select wrr to use Weighted Round Robin (WRR) Scheduling. WRR services queues on a
rotating basis based on their queue weight (the number you configure in the queue weight
fields). Queues with larger weights get more service than queues with smaller weights.
These fields apply when you select the wrr queuing algorithm in the Algo_Type field.
Use these fields to set the priority weight (0~15) of each queue on a Gigabit Ethernet
interface (or trunk group if trunking is enabled). The higher a queue's weight, the more
service it gets.
Click Apply to save the changes in this screen to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile memory
when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Management Switch Card User's Guide