Alarm E1 Profile Screen - ZyXEL Communications MSC1000G User Manual

The following table describes the labels in this screen.
Table 190 Profile > Dialplan
LABEL
Name
Default SIP
Profile
Index
Apply
New
Cancel
Index
Name
Select
Modify
Delete

11.29 Alarm E1 Profile Screen

Click Profile> Alarm E1 in the navigation panel to open the following screen. Use this screen to
configure alarm profiles for the E1 ports. Later you can apply the alarm E1 profiles to E1 ports in
the E1 Port Setup screens.
Alarm E1 profiles define E1 port alarm thresholds. The system sends an alarm trap and generates a
syslog entry when the thresholds of the alarm profile are exceeded.
Management Switch Card User's Guide
DESCRIPTION
Specify a name for the profile of dial plans.
Specify the default SIP profile for the dial plan profile. The system uses the default SIP profile
instead when a dialed number does not match any entries in this dial plan profile.
This is an incremental number indicating the order in which to apply the VoIP dial plans included
in the profile.
Select a dial plan from the drop-down list box.
Click Apply to save the changes in this screen to the system's volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile memory
when you are done configuring.
While you are modifying a profile, you can click New to start configuring a fresh profile without
saving your changes.
Click Cancel to start configuring the screen again.
This is an incremental number indicating the order in which the profiles were created.
This is the name of the profile.
Select the profile you wish to load or delete.
Select a profile and click this in order to edit its configuration.
Select a profile and click this to delete the profile. Once deleted, information cannot be retrieved.
Chapter 11 Profile Screens
409