ZyXEL Communications MSC1000G User Manual page 378

Chapter 11 Profile Screens
Table 178 Profile > VoIP SIP CALLSVC Screen
LABEL
Number Plan
Call Service Mode
First Digit Time
Inter Digit Time
Countrycode
National Destination
Code
Number Plan Table
DTMF Relay
Fax Service
Flash
378
DESCRIPTION
Select ON to use the number plan table specified in the Number Plan Table field.
Select OFF to use no number plan table.
Select the mode for supplementary phone services (call hold, call
waiting, call transfer and three-way conference calls).
europe - use European-style supplementary phone services
usa - use American-style supplementary phone services
Set the length of time a person has to dial the first digit after taking the phone off-hook
before hearing the howler tone.
Set the length of time a person has between dialing digits before hearing the howler
tone.
Enter the numeric code for the country of operation. This value is used by the number
plan table's "\c" function (see
Enter the numeric code for the region of operation. This value is used by the number
plan table's "\d" function (see
Select the number plan you want to use for this call service profile. Configure number
plans in the VoIP > Number Plan Table screens.
Choose the method of relaying DTMF (Dual-Tone Multi-Frequency) tones configured on
the peer device.
Select Bypass to not relay DTMF tones.
Select RFC2833 to relay DTMF tones according to RFC 2833.
Select RFC2833 Like to relay DTMF tones in SIP INFO packets, but carried as RFC
2833 payload.
Select SIP Info to relay DTMF tones as SIP INFO messages.
Choose the fax method configured on the peer device.
Select T.38 to send fax signals according to ITU-T T-38.
Select G.711 to send fax signals according to ITU-T G.711.
Use this field to select the method the system uses to process the flash signal from a
user.
• Invite: relays flash by SIP INVITE signal. The flash type cannot be Invite when
you use the v5sip Op Mode.
• Rfc2833: relays flash according to RFC 2833.
• RFC2833 Like: relays flash in SIP INFO packets, but carried as RFC 2833 payload
• SIP Info 1: relays flash in SIP INFO packets (a signal=16 message)
• SIP Info 2: relays flash in SIP INFO packets (a signal=hf message)
• SIP Info 3: relays flash in SIP INFO packets (a signal=hook-flash message)
• SIP Info 4: relays flash in SIP INFO packets (a plain text "FLASH" message).
• SIP Info 5: relays flash in SIP INFO packets (multiple SIP messages). The
message content is determined by the characters you enter in the field that
appears to the right of the list. A separate SIP INFO message is sent for each
character you enter.
• SIP Info 6: relays flash in SIP INFO packets (where the content of the message is
determined by the text you enter in the field that appears to the right of the list).
Section 16.9 on page 623).
Section 16.9 on page 623).
Management Switch Card User's Guide