Igmp Bandwidth Screen - ZyXEL Communications MSC1000G User Manual

Table 76 IGMP Port Setup (continued)
LABEL
State
Card Type
Up Time
Firmware

8.3.2 IGMP Bandwidth Screen

Click Multicast > IGMP > Bandwidth to open the following screen.
Figure 115 Multicast > IGMP > Bandwidth
The following table describes the labels in this screen.
Table 77 Multicast > IGMP > Bandwidth
LABEL
Default
Bandwidth
Index
Management Switch Card User's Guide
DESCRIPTION
This field displays the line card's current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could be due
to the card starting, a firmware upgrade in progress or a malfunction. See
page 1105 for what to do if the line card stays stuck in the inactive state.
This field displays the type of a line card.
This field displays how long the line card has been running since the last time it was started.
This field displays the current firmware version installed on the line card.
DESCRIPTION
Select the maximum bandwidth allowed for multicast traffic for which you have not
configured bandwidth requirements yet. The multicast bandwidth settings on ports (see the
Bandwidth field below) have higher priority over this default setting. Click Apply to save
the changes in this section to the system's volatile memory.
Specify the index number of a multicast group.
Chapter 8 Multicast Screens
Chapter 38 on
191