ZyXEL Communications MSC1000G User Manual page 340

Chapter 11 Profile Screens
Figure 219 Profile > VDSL2
The following table describes the labels in this screen.
Table 159 Profile > VDSL2
LABEL
Name
VDSL2 Line Profile
VDSL2 Channel
Profile
VDSL2 Inm Profile
Rate Adaption Ratio
Channel 1
Apply
New
Cancel
Index
Name
VDSL2 Line Profile
VDSL2 Channel
Profile
Modify
Delete
340
DESCRIPTION
Enter a descriptive name to identify this template.
Select a line profile for this VDSL2 template. You can configure line profiles by clicking
the LineProfile link in the right-top corner of the screen.
Select a channel profile for this VDSL2 template. You can configure channel profiles by
clicking the ChanProfile link in the right-top corner of the screen.
Select an Impulse Noise Monitoring (Inm) profile for this VDSL2 template. Click the
InmProfile link in the right-top corner of the screen to configure impulse noise
monitoring profiles.
This field displays the transmission rate distribution ratio between upstream and
downstream traffic for channel 1 in this template.
Click Apply to save the changes in this screen to the system's volatile memory. The
system loses these changes if it is turned off or loses power, so use the Config Save
link on the navigation panel and then the Save button to save your changes to the non-
volatile memory when you are done configuring.
The new or modified VDSL2 template then displays in the summary table below.
While you are modifying a profile, you can click New to start configuring a fresh profile
without saving your changes.
Click Cancel to start configuring the screen again.
This is the number of a VDSL2 template.
This field displays the descriptive name for each configured VDSL2 template.
This field displays the line profile name configured in each VDSL2 template.
This field displays the channel profile name configured in each VDSL2 template.
Select a profile's Select radio button and click Modify to edit the profile.
Select a profile's Select radio button and click Delete to remove the profile.
Management Switch Card User's Guide