Parameter Setting (Detection Point) - Omron FH-3 Series Reference Manual

Parameter Setting (Detection Point)

Set how to acquire position/angle data necessary to set detection points.
1
Select the setting method for detection
points in the [Setting type] area.
Setting item
Setting type
When you choose [Calculation] as the setting method.
2
Set the position and angle used as the detection point in the [Position angle] are using the
arithmetic expression.
Reference: Layout of Setting Expression Window (p.621)
3
The position/angle values used as the
detection point can be confirmed in the
[Setting data] area.
The calculation result specified in the [Setting
type] and [Position angle] areas is displayed.
If the value is not updated, exit the setting
screen once and display it again after
executing the measurement.
FH/FZ5 Processing Item Function Reference Manual
Setting value
[Factory default]
Calculate the position and angle used as the detection point from data in
the previous Processing Unit. If the previous Processing Unit has not
[Nearest unit]
calculation strings X/Y, judgement in this Processing Unit will be NG
during measurement.
Calculate the position and angle used as the detection point using the
Calculation calculation formula.
Selecting the arithmetic expression enables the "Position/Angle" area.
Description
Detection Point
4
811