Omron FH-3 Series Reference Manual page 77

Electronic Flash Setting
This function is set when an electronic flash is used. This sets the output conditions for the signal for
synchronizing the measurement and the electronic flash timing.
Important
• The STGOUT signals that can be output are as follows.
: FH-1000 and FH-3000 series: SGTOUT 0 to 7
: FH-L series: STGOUT 0 to 3
• STGOUT0 to STGOUT7 is tied to The camera connector number of the sensor controller, not the camera number.
When you use CameraLink Medium Configuration or the Multi-line random-trigger mode, confirm the camera connector
number that corresponds to the camera number of sensor Controller.
1
In the Item Tab area, click [Camera setting].
2
In the Electronic flash setting area, set
the items of STGOUT signals.
Item
STGOUT select
STEP-STGOUT
delay
STGOUT width
STGOUT polarity
FH/FZ5 Processing Item Function Reference Manual
Setting value
[Factory default]
Select the STGOUT signal to use for Camera Image Input HDR
processing item.
[The same as the input
The same as the input camera: STGOUT that is tied to the input
camera]
camera is output.
Camera 0 to 7
Camera 0 to 7: STGOUT signal that is tied to the selected camera
is output.
Set the time to wait to turn ON the electronig flash trigger signal
after STEP signal is input.
Delay time = count number ×30μs+90μs
[0] to 511
Delay time changes with the setting of STGOUT polarity.
(1 count is 30μs)
The time displayed is for the polarity of Positive; for Negative,
35μs will be added to the displayed time.
Delay time is within the range ±10μs of set value.
0 to 43689
Set the time to output the electronic flash trigger signal.
[3]
For FH series controller, set 0 to disable flashing.
(1count is 30μs)
Set the pulse polarity of electronic flash trigger.
Positive: flashes synchronizing with the electronic flash trigger
• [Positive]
output changing from OFF→ON.
• Negative
Negative: flashes synchronizing with the electronic flashing trigger
output changing from ON→OFF.
Description
Camera Image Input HDR
1
75