Omron FH-3 Series Reference Manual page 114

3
Use the drawing tools to specify the model registration range.
4
Click [OK] in the Figure setting area.
• [OK]: Changes the settings and returns to
the previous menu.
• [Cancel]: Changes are discarded. Returns to
the previous menu.
• [Apply]: Updates the settings without leaving
edit window.
5
To register two or more models, repeat
the Steps Reference:
Reference: 
Important
• When a model is registered, the center of the model is registered
as the detection point. A detection point is a point output as a
measurement value. If multiple figures are combined, the central
coordinates of the circumscribed rectangle are registered.
Changing Model Parameters
Model parameter values can be changed as needed to address unstable measurement results or to increase the
processing speed. Normally, the factory default value will be used.
After changing a setting, re-register the model.
1
In the "Model parameter" area, select the
search mode, then specify a value for
each item for that mode.
Setting item
Search mode
112
Flexible Search
 2 (p.111) to
4 (p.112).
Set value
[Factory default]
Search for normalizing the brightness. This method can provide stable
[CR] measurement when there is fluctuation in the overall brightness and when the
image has low contrast.
Measures the degree of matching with the model profile. This method can
PT measure at higher speed when the rotation angle has a wide range.
It is available only when a 0.3 megapixel color camera is connected.
Detection coordinate
Can be changed to an appreciate position.
Model
Description
FH/FZ5 Processing Item Function Reference Manual