Omron FH-3 Series Reference Manual page 377

Setting item
Defect judge
Area judge
Defect number
4
If necessary, set the display conditions
for displayed images.
Setting item
Profile
Element
Disp Region
FH/FZ5 Processing Item Function Reference Manual
Setting value
[Factory default]
0 to 999
0 to 999,999,999.9999
0 to 307,200 (0.3 megapixel cameras)
0 to 1,920,000 (2 megapixel cameras)
0 to 4,320,000 (5 megapixel cameras)
0 to 2,500
Set value
[Factory default]
Set the profile display.
Defect
level
• [Checked]
• Unchecked
0
The maximum degree of defect along the X(circumferential) andY(radial)
is displayed with red lines.
If you click in the measurement region on the image area, the profile in
the XY directions from this point is displayed with yellow lines.
Set the comparison element display.
Elements are created automatically
during measurement. The density is
• Checked
calculated for each element and the
• [Unchecked]
position of defects/contamination is
detected from the degree of their
variation.
Place a check to display the defect area.
• [Checked]
If checked, specify More than upper limit (Defct) or More than lower limit
• Unchecked
(Pattern).
Description
Specify the range of defect judgement values
that are judged to be OK.
Specify the range of area judgement values that
are judged to be OK.
Specify the range of the number of defects that
are judged to be OK.
Description
Element
2
Defect
375
Precise Defect