Omron FH-3 Series Reference Manual page 251

3
Set the value of each item in the "Measurement" area.
For color cameras:
Edge Color Not Specified
Setting item
Edge No.
Edge Upper (only
when edge color is
not specified)
Edge Lower
Edge color level
For monochrome cameras:
When the measurement method is "Projection"
Setting item
Measure type
FH/FZ5 Processing Item Function Reference Manual
Set value
[Factory default]
Specify the edge number used to extract edges.
0 to 99 Edge numbers are assigned to detected edges starting from 0 and going
[0] on in the direction from the start point (the arrow point) to the end point
(the direction of arrow) in the selected area.
• Position (%) for
width of a color
Set a range of a color difference level with which the edge is detected.
0 to 100
Reference: "Appendixes Measurement Mechanism Edge Detection
[50] to [100]
Measurement" in the "Vision System FH/FZ5 Series User's Manual
• Value of color
(Z365)"
0 to 442
[20] to [442]
0 to 442 This emphasis level can be specified only if the edge color to detect is
[100] specified.
Set value
[Factory default]
As the measurement type, specify either projection or derivation.
• [Projection]
Reference: "Appendixes Measurement Mechanism Edge Detection
• Derivation
Method" in the "Vision System FH/FZ5 Series User's Manual (Z365)"
Edge Color Specified
Description
When the measurement method is "Derivation"
Description
249
Scan Edge Position
2