Omron FH-3 Series Reference Manual page 343

Setting item
Outside trimming
Sort condition
Sort order
Label No.
Label maximum
3
If necessary, in the "Display setting" area, set up display settings for the images displayed in
the Image Display area.
FH/FZ5 Processing Item Function Reference Manual
Set value
[Factory default]
• Checked
• [Unchecked]
• [Area]
• X
• Y
• Elliptic major axis
• Elliptic minor axis
• Elliptic ratio
• Rectangle width
• Rectangle height
• Rectangle X1
• Rectangle Y1
• Perimeter
• Circularity
• Fit rect major axis
• Fit rect minor axis
• Fit rect ratio
• Inscribed circle X
• Inscribed circle Y
• Inscribed circle R
• Circum. circle X
• Circum. circle Y
• Circum. circle R
• Number of holes
• Ascending
• [Descending]
FZ5-L Series / FZ5-600
Series: 0 to 2499 [0]
FH Series / FZ5-800 Series
/ FZ5-1100 Series / FZ5-
1200 Series: 0 to 9998 [0]
FZ5-L Series / FZ5-600
Series: 1 to 2500 [2500]
FH Series / FZ5-800 Series
/ FZ5-1100 Series / FZ5-
1200 Series: 1 to 9999
[2500]
Description
This option can be used only when there is a section of the
designated color in the measurement region that does not need to
be measured.
When "Checked" is set, the whole area outside of the
measurement region is extracted as having the specified color.
Measurement region
When calculating The area outside of the measurement
the position and region turns the color of the measurement target.
area of this label Sort mode: Area descending
Label No.: 1
With the settings above, the position and area of
the middle label will be measured.
Specify the conditions by which label number is re-assigned.
When sorting referencing the X and Y coordinates, the upper left is
the origin.
Set the direction for sorting.
Ascending: Numbers are assigned from smaller values to larger.
Descending: Numbers are assigned from larger values to smaller.
Set the label number for the data to be output.
Set the maximum number of labels to be output.
2
341
Labeling