Omron FH-3 Series Reference Manual page 772

3
Check the calibration data items that you want to set.
Calibration data is created for the checked numbers.
4
Select the line of the calibration data that you want to set.
5
Set each item in the "Calibration target" area.
Setting item
Position X
Position Y
Judge expression
Judge condition
770
PLC Master Calibration
Setting value
[Factory default]
---
---
---
-999999999.9999 to
999999999.9999
[1.0000] to [1.0000]
Description
Set the arithmetic expression that obtains camera
coordinate X used for sampling.
Set the arithmetic expression that obtains camera
coordinate Y used for sampling.
Set the arithmetic expression to determine whether
sampling was successful or not.
If calibration fails during the initial value TJG, set the unit
judgement JG of the processing unit from which positions X
and Y are referred.
Set the upper and lower limit values to determine whether
sampling was successful or not.
If TJG or JG is set to the judgement expression, use the
initial values.
FH/FZ5 Processing Item Function Reference Manual