Focus
This function helps you bring the camera into focus.
Used in the Following Case
• Use this function to make adjustments so as to facilitate inspection of input images that tend
to become out of focus.
focus has shifted due to change in the height of the target work, etc., adjust the focus.
Before processing
Important
• Processing is different for color images and monochrome images. If the camera type, color camera, or monochrome
camera, was changed from a previous setup, a reset of some settings may be needed.
Measurement Parameters (Focus)
Measurement parameters can be changed as needed to address unstable focus values.
1
In the Item Tab area, click [Measurement].
2
In the "Display" area, click [Change display] to switch between camera image types.
(Re-measurement images are not shown on the setting window.)
Setting item
ON
692
Focus
Set value
Through
The latest image is always input from the camera and displayed.
The image that was scanned in the immediately preceding
Freeze
measurement is displayed.
After processing
Description
FH/FZ5 Processing Item Function Reference Manual