Omron FH-3 Series Reference Manual page 105

Setting item
Sort condition
0 to 127
Search No.
[0]
3
When the setting has been changed,
click [Measure] in the Detail area to
verify whether measurements can be
made correctly.
4
Set up the judgement condition.
Note
• The values beside each item are measurement results of the displayed image. Take these values into
consideration to determine the upper and lower limit values.
Setting item
Count 0 to 128
Measure X -99999.9999 to 99999.9999
Measure Y -99999.9999 to 99999.9999
Search angle -180 to 180
Correlation 0 to 100
FH/FZ5 Processing Item Function Reference Manual
Set value
[Factory default]
• Corr. ascending
• [Corr.
descending]
• X coordinate
ascending Specify the conditions by which the search number is re-assigned.
• X coordinate When sorting referencing the X and Y coordinates, the upper left is the
descending origin.
• Y coordinate
ascending
• Y coordinate
descending
Specify which of the multiple detection results will be used as measured
results.
Set value
Description
Description
Specify the number of detections that are judged to be OK.
Specify the range of X-axis shifting that is judged to be OK.
Specify the range of Y-axis shifting that is judged to be OK.
Specify the range of angles that are judged to be OK.
Specify the range of correlation values that are judged to be
OK. However, when the correlation value of the measurement
result is 0, the judgement result will be NG regardless of the
lower limit setting.
2
103
Search