Measurement Parameters (Search) - Omron FH-3 Series Reference Manual

Referencing a unit
Set a reference by referencing a detection point unit with registered X coordinate, Y coordinate and angle data.
1
In the Item Tab area, click [Ref. setting].
In the display area, the current reference position will be displayed as the crosshair cursor.
2
In the "Method" area, select "Unit".
3
In the scene in the "Unit" area, select a
detection point unit.
4
Perform the next measurement, and the reference will be displayed.

Measurement Parameters (Search)

Specify the search measurement conditions and the judgement conditions for the measurement results.
1
In the Item Tab area, click [Measurement].
2
In the "Measurement condition" area,
specify a value for each item.
Setting item
Sub-pixel
Candidate LV
When executing a multi search
Setting item
Multiple output
Count
Detail LV
102
Search
Set value
[Factory default]
When a check is placed at sub-pixel, the position information can be
• Checked
measured in units of sub-pixels. However, this requires more processing
• [Unchecked]
time.
0 to 100 Specify the threshold value with which to detect candidate points in a rough
[70] search. Specify a smaller value when model search results are unreliable.
Set value
[Factory default]
• Checked
Select to execute a multi searches.
• [Unchecked]
This executing item is available when Multi search is executed.
1 to 128 Specify the maximum number of detections.
[32] If it detects more objects than the specified value, these matches are
sorted out to output up to the specified value from the top.
0 to 100 Specify the threshold value with which to detect candidate points in a detail
[75] search.
Description
Description
FH/FZ5 Processing Item Function Reference Manual