Omron FH-3 Series Reference Manual page 174

Registering a model through image generation (Create image)
You can register a model using shapes provided in Shape Search III. Use this function when the captured image
has excessive noise, or the shape in the image to register as the model is unclear, or is missing a part.
1
In the [Input type] area, select [Create
image].
2
Adjust each setting in the [Figure type]
area.
Setting item
Figure type
Empty middle
Offset
Smooth count
Equal XY
172
Shape Search III
Setting value
[Factory default]
• [Cross]
• Circle Select the type of figure to be used for the generated image
• Rectangle model.
• Diamond
• Checked Select whether or not to make the generated image hollow.
• [Unchecked] Select the setting according to the shape of the detection object.
Set how much margins will be provided for the model when it is
registered.
0 to 99 Set a value that is larger than the smooth count. If you set a
[5] rotation angle, increase the value even more.
Model registration will not be possible if the model region extends
beyond the image. If that occurs, reduce the value.
Set the level of smoothing applied to the generated figure
0 to 9 according to the condition of the outline of the detection object. If
[1] the outline is clear, reduce the value. If the outline is not clear,
increase the value.
• Checked If you place a check here, the length and width settings will
• [Unchecked] become the same for X and Y.
Description
FH/FZ5 Processing Item Function Reference Manual