Configure An X330 Expansion Module (If Necessary); Check For Ip Connections - Avaya G700 Installation And Upgrades

3 Configuring a New G700 with an S8300 (Primary Controller or Local Survivable Processor):
Configure an X330 Expansion Module (If
Necessary)
Begin
1. See the Avaya X330W-2DS1 Access Router Module Quick Start Guide. This document is
available at http://avayanetwork.com. Once there, select:
> Software Download
> Avaya P330
Select the Quick Start Guide for X330WAN 2DS1.
2.
End

Check for IP Connections

Begin
After you have assigned IP addresses to the P330 Stack Processor (Layer 2 Switching Processor),
the G700 Media Gateway MGP, Media Modules, and the VoIP resources, do the following to
check for IP connections:
At the MG-???-n(config)# prompt, type ping mgp <IP_address>
1.
where <IP_address> is the address of an S8300 or S8700 server, the VoIP engine, or any other
functioning endpoint accessible on the customer's LAN. It is recommended to ping endpoints on
both the same subnet and a different subnet.
Ping results appear on the screen, similar to the following example.
Installation and Upgrades for the G700 with an S8300/S8700
555-234-100 — Issue 2 — October 2002
> Technical Documentation
> Avaya X330 WAN
113