Test The Oscillate Axle (If Equipped); Perform 30 Day Service - Genie S-60 HC Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST A PROCEDURES
A-6
Test the Oscillate Axle
(if equipped)
Note: Genie specifications require that this
procedure be performed daily or every 8 hours,
whichever comes first.
Proper axle oscillation is essential to safe machine
operation. If the axle oscillation system is not
operating correctly, the stability of the machine is
compromised and it may tip over.
1 Start the engine from the platform controls.
2 Drive the right steer tire up onto a
6 inch / 15 cm block or curb.
Result: The three remaining tires should stay in
firm contact with the ground and the chassis
should remain level at all times.
3 Drive the left steer tire up onto a
6 inch / 15 cm block or curb.
Result: The three remaining tires should stay in
firm contact with the ground and the chassis
should remain level at all times.
4 Drive both steer tires up onto a
6 inch / 15 cm block or curb.
Result: The non-steer tires should stay in firm
contact with the ground.
Note: If the chassis does not remain level during
test, refer to Repair Procedure 7-6, How to Set Up
the Oscillate Directional Valve.
3 - 10
A-7

Perform 30 Day Service

The 30 day maintenance procedure is a one time
sequence of procedures to be performed after the
first 30 days or 40 hours of usage, whichever
comes first. After this interval, refer to the
maintenance tables for continued scheduled
maintenance.
1 Perform the following maintenance procedures:
• A-9
• A-12
• B-6
• B-8
• C-1
• D-2
• D-6
S-60 • S-65 • S-60 HC
February 2012
Perform Engine Maintenance -
GM, Ford and Perkins Models
Grease the Turntable Bearing and
Rotate Gear
Inspect the Tires, Wheels and
Lug Nut Torque
Check the Drive Hub Oil Level and
Fastener Torque
Perform Engine Maintenance -
Deutz Models
Check the Turnable Rotation
Bearing Bolts
Replace the Hydraulic Filters
Part No. 77828