Perform 30 Day Service; Test The Oscillate Axle (If Equipped) - Genie S-65 Service Manual

Section 3 • Scheduled Maintenance Procedures
CHECKLIST A PROCEDURES
A-7
Test the Oscillate Axle
(if equipped)
Proper axle oscillation is essential to safe machine
operation. If the axle oscillation system is not
operating correctly, the stability of the machine is
compromised and it may tip over.
1 Start the engine from the platform controls.
2 Drive the right steer tire up onto a
6 inch / 15 cm block or curb.
Result: The three remaining tires should stay in
firm contact with the ground and the chassis
should remain level at all times.
3 Drive the left steer tire up onto a
6 inch / 15 cm block or curb.
Result: The three remaining tires should stay in
firm contact with the ground and the chassis
should remain level at all times.
4 Drive both steer tires up onto a
6 inch / 15 cm block or curb.
Result: The non-steer tires should stay in firm
contact with the ground.
If the chassis does not remain
level during test, see Repair
Procedure 7-6, How to Set Up the
Oscillate Directional Valve.
3 - 10
A-8

Perform 30 Day Service

The 30 day maintenance procedure is a one time
sequence of procedures to be performed after the
first 30 days or 50 hours of usage, whichever
comes first. After this interval, refer to the
maintenance tables for continued scheduled
maintenance.
1 Perform the following maintenance procedures:
• A-9 Perform Engine Maintenance -
GM, Ford and Perkins Models
• A-12 Grease the Turntable Bearing and
Rotate Gear
• B-5 Check the Lug Nut Torque
(including tires and wheels)
• B-7 Check the Oil Level in the Drive Hubs
• C-1 Perform Engine Maintenance -
Deutz Models
• D-2 Check the Turnable Rotation Bearing
Bolts
• D-6 Replace the Hydraulic Filters
S-60 • S-65
July 2005
REV C
Part No. 77828