REV A
5 Install the chassis hose cover removed in step
6 of the Oscillate Hose Routing section.
6 Turn the key switch to platform controls and
pull out the red Emergency stop buttons to the
on position at both the ground and platform
controls. Start the engine.
7 Raise the platform to approximately 10 ft / 3 m.
8 Return the safety arm to the cradle.
9 Lower the platform to the stowed position.
Continue to Test the Oscillate Axle.
Part No. 237339
Test the Oscillate Axle
Note: Genie specifications require that this
procedure be performed daily or every 8 hours,
whichever comes first.
Proper axle oscillation is essential to safe machine
operation. If the axle oscillation system is not
operating correctly, the stability of the machine is
compromised and it may tip over.
1 Start the engine from the platform controls.
Select the high idle function.
Test the Oscillate System (stowed position):
2 Drive the left front wheel up onto a 4 in / 10 cm
high ramp.
Result: The three remaining tires should stay in
firm contact with the ground.
3 Drive the right steer tire up onto a 4 in / 10 cm
high ramp.
Result: The three remaining tires should stay in
firm contact with the ground.
If the oscillate system does not operate as
stated, do not proceed. Re-check the wiring,
limit switches and hydraulic hoses.
Test the Oscillate System (elevated position):
4 Push and hold the lift function enable button
and raise the platform between 7 ft / 213 cm to
9 ft / 274 cm.
GS-69 RT Models
Inspection and Repair Instructions
PROCEDURE
9