Test The Alarm Package (If Equipped) - Genie S-100 Service Manual

Section 4 • Scheduled Maintenance Procedures
CHECKLIST B PROCEDURES
2 Release the latches on the air cleaner cap.
Remove the end cap from the air cleaner
canister.
3 Remove the filter element.
4 Clean the inside of the canister and the end cap
with a damp cloth.
5 Inspect the air filter element. If needed, blow
from the inside out using low pressure dry
compressed air, or carefully tap out dust.
Replace the filter if needed.
6 Install the filter element.
7 Install the air filter canister end cap and secure
the end cap latches.
Be sure the discharge slot is
pointing down.
4 - 22
B-5
Test the Alarm Package
(if equipped)
Alarms and a beacon are installed to alert operators
and ground personnel of machine proximity and
motion. The alarm package is installed on the
turntable covers.
1 Turn the key switch to ground control and pull
out the Emergency Stop button to the on
position at both the ground and platform
controls.
Result: The flashing beacon should be on and
flashing.
2 Push and hold a function enable/speed select
button and the boom down button. Hold for a
moment and then release them.
Result: The descent alarm should sound when
the boom down button is pressed.
3 Turn the key switch to platform control.
Result: The flashing beacon should be on
and flashing.
4 Press down the foot switch. Move the boom
control handle to the down position, hold for a
moment and then release it.
Result: The descent alarm should sound when
the control handle is held down.
5 Press down the foot switch. Move the drive
control handle off center, hold for a moment and
then release it. Move the drive control handle off
center in the opposite direction, hold for a
moment and then release it.
Result: The travel alarm should sound when the
drive control handle is moved off center in either
direction.
S-100 & S-105 & S-120 & S-125
January 2010
The alarms and beacon will
operate with the engine
running or not running.
Part No. 62401
REV B