Show Startup-Config; Show System - Edge-Core ECS4610-24F Management Manual

| System Management Commands
C 24
HAPTER
System Status

show startup-config

show system

R C
ELATED OMMANDS
show startup-config (590)
This command displays the configuration file stored in non-volatile memory
that is used to start up the system.
C M
OMMAND ODE
Privileged Exec
C U
OMMAND SAGE
Use this command in conjunction with the show running-config
◆
command to compare the information in running memory to the
information stored in non-volatile memory.
This command displays settings for key command modes. Each mode
◆
group is separated by "!" symbols, and includes the configuration mode
command, and corresponding commands. This command displays the
following information:
MAC address for the switch
■
SNMP community strings
■
Users (names, access levels, and encrypted passwords)
■
VLAN database (VLAN ID, name and state)
■
VLAN configuration settings for each interface
■
Multiple spanning tree instances (name and interfaces)
■
IP address configured for VLANs
■
Layer 4 precedence settings
■
Routing protocol configuration settings
■
Spanning tree settings
■
Interface settings
■
Any configured settings for the console port and Telnet
■
E
XAMPLE
Refer to the example for the running configuration file.
R C
ELATED OMMANDS
show running-config (588)
This command displays system information.
D S
EFAULT ETTING
None
C M
OMMAND ODE
Normal Exec, Privileged Exec
C U
OMMAND SAGE
For a description of the items shown by this command, refer to
◆
"Displaying System Information" on page
– 590 –
101.