Passive-Interface - Edge-Core ECS4610-24F Management Manual

| IP Routing Commands
C 45
HAPTER
Routing Information Protocol (RIP)

passive-interface

C U
OMMAND SAGE
RIP only sends and receives updates on interfaces specified by this
command. If a network is not specified, the interfaces in that network will
not be advertised in any RIP updates.
E
XAMPLE
This example includes network interface 10.1.0.0 in the RIP routing
process.
Console(config-router)#network 10.1.0.0
Console(config-router)#
R C
ELATED OMMANDS
router rip (1025)
This command stops RIP from sending routing updates on the specified
interface. Use the no form to disable this feature.
S
YNTAX
[no] passive-interface vlan vlan-id
vlan-id - VLAN ID. (Range: 1-4093)
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Router Configuration
C U
OMMAND SAGE
If this command is used to stop sending routing updates on an
◆
interface, the attached subnet will still continue to be advertised to
other interfaces, and updates from other routers on that interface will
continue to be received and processed.
Use this command in conjunction with the
◆
control the routing updates sent to specific neighbors.
E
XAMPLE
Console(config-router)#passive-interface vlan1
Console(config-router)#
R C
ELATED OMMANDS
neighbor (1029)
– 1030 –
neighbor command to