Edge-Core ECS4610-24F Management Manual page 138

| Interface Configuration
C 5
HAPTER
Trunk Configuration
Select Configure Trunk from the Step list.
2.
Select Add Member from the Action list.
3.
Select a trunk identifier.
4.
Set the unit and port for an additional trunk member.
5.
Click Apply.
6.
Figure 33: Adding Static Trunks Members
To configure connection parameters for a static trunk:
Click Interface, Trunk, Static.
1.
Select Configure General from the Step list.
2.
Select Configure from the Action list.
3.
Modify the required interface settings. (Refer to
4.
List" on page 125 for a description of the parameters.)
Click Apply.
5.
Figure 34: Configuring Connection Parameters for a Static Trunk
To display trunk connection parameters:
Click Interface, Trunk, Static.
1.
Select Configure General from the Step list.
2.
– 138 –
"Configuring by Port