Dhcp Relay; Ip Dhcp Relay Server; Table 130: Dhcp Relay Commands - Edge-Core ECS4610-24F Management Manual

24-port layer 3 gigabit ethernet switch

Hide thumbs Also See for ECS4610-24F:

Table of Contents

| DHCP Commands

DHCP Relay

DHCP requires the server to reassign the client's last address if

If the BOOTP or DHCP server has been moved to a different domain,

the network portion of the address provided to the client will be based

on this new domain.

In the following example, the device is reassigned the same address.

Console(config)#interface vlan 1

Console(config-if)#ip address dhcp

Console(config-if)#exit

Console#ip dhcp restart client

Console#show ip interface

Vlan 1 is Administrative Up - Link Up

Address is 12-34-12-34-12-34 (bia 12-34-12-34-12-34)

Index: 1001, MTU: 1500, Bandwidth: 1g

Address Mode is DHCP

IP Address: 192.168.0.9 Mask: 255.255.255.0

Proxy ARP is disabled

ip address (1006)

This section describes commands used to configure DHCP relay functions

for host devices attached to the switch.

ip dhcp relay server

Specifies DHCP server addresses for relay

ip dhcp restart relay

Enables DHCP relay agent

This command specifies the addresses of DHCP servers to be used by the

switch's DHCP relay agent. Use the no form to clear all addresses.

ip dhcp relay server address1 [address2 [address3 ...]]

no ip dhcp relay server

address - IP address of DHCP server. (Range: 1-3 addresses)

Show Quick Links

Table of Contents