Set Phb - Edge-Core ECS4610-24F Management Manual

24-port layer 3 gigabit ethernet switch
Hide thumbs Also See for ECS4610-24F:
Table of Contents

Advertisement

| Quality of Service Commands
C
38
HAPTER

set phb

C
U
OMMAND
SAGE
The set cos command is used to set the CoS value in the VLAN tag for
matching packets.
The set cos and
set phb
priority. Therefore setting either of these commands will overwrite any
action already configured by the other command.
E
XAMPLE
This example creates a policy called "rd-policy," uses the
specify the previously defined "rd-class," uses the set cos command to
classify the service that incoming packets will receive, and then uses the
police flow
command to limit the average bandwidth to 100,000 Kbps, the
burst rate to 4000 bytes, and configure the response to drop any violating
packets.
Console(config)#policy-map rd-policy
Console(config-pmap)#class rd-class
Console(config-pmap-c)#set cos 3
Console(config-pmap-c)#police flow 10000 4000 conform-action transmit
violate-action drop
Console(config-pmap-c)#
This command services IP traffic by setting a per-hop behavior value for a
matching packet (as specified by the
the IP header. Use the no form to remove this setting.
S
YNTAX
[no] set phb phb-value
phb-value - Per-hop behavior value. (Range: 0-7)
D
S
EFAULT
ETTING
None
C
M
OMMAND
ODE
Policy Map Class Configuration
C
U
OMMAND
SAGE
The set phb command is used to set the per-hop behavior value in the
IP header for matching packets.
The
set cos
and set phb command function at the same level of
priority. Therefore setting either of these commands will overwrite any
action already configured by the other command.
– 898 –
command function at the same level of
match
command) in the ToS field of
class
command to

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents