Default-Information Originate; Default-Metric - Edge-Core ECS4610-24F Management Manual

| IP Routing Commands
C 45
HAPTER
Routing Information Protocol (RIP)
default-information
originate

default-metric

This command generates a default external route into the local RIP
autonomous system. Use the no form to disable this feature.
S
YNTAX
[no] default-information originate
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Router Configuration
C U
OMMAND SAGE
This command sets a default route for every Layer 3 interface where RIP is
enabled. The response packet to external queries marks each active RIP
interface as a default router with the IP address 0.0.0.0.
E
XAMPLE
Console(config-router)#default-information originate
Console(config-router)#
R C
ELATED OMMANDS
ip route (1020)
redistribute (1031)
This command sets the default metric assigned to external routes imported
from other protocols. Use the no form to restore the default value.
S
YNTAX
default-metric metric-value
no default-metric
metric-value – Metric assigned to external routes. (Range: 1-15)
D S
EFAULT ETTING
1
C M
OMMAND ODE
Router Configuration
C U
OMMAND SAGE
This command does not override the metric value set by the
◆
redistribute command. When a metric value has not been configured by
the redistribute command, the default-metric command sets the
metric value to be used for all imported external routes.
– 1026 –