Ip Http Secure-Port; Telnet Server; Table 61: Telnet Server Commands - Edge-Core ECS4610-24F Management Manual

ip http secure-port

T S
ELNET ERVER
This command specifies the UDP port number used for HTTPS connection to
the switch's web interface. Use the no form to restore the default port.
S
YNTAX
ip http secure-port port_number
no ip http secure-port
port_number – The UDP port used for HTTPS. (Range: 1-65535)
D S
EFAULT ETTING
443
C M
OMMAND ODE
Global Configuration
C U
OMMAND SAGE
You cannot configure the HTTP and HTTPS servers to use the same
◆
port.
If you change the HTTPS port number, clients attempting to connect to
◆
the HTTPS server must specify the port number in the URL, in this
format: https://device:port_number
E
XAMPLE
Console(config)#ip http secure-port 1000
Console(config)#
R C
ELATED OMMANDS
ip http secure-server (679)
show system (590)
This section describes commands used to configure Telnet management
access to the switch.

Table 61: Telnet Server Commands

Command Function
ip telnet max-sessions Specifies the maximum number of Telnet sessions
that can simultaneously connect to this system
ip telnet port Specifies the port to be used by the Telnet interface
ip telnet server Allows the switch to be monitored or configured from
Telnet
show ip telnet Displays configuration settings for the Telnet server
– 681 –
| Authentication Commands
C 27
HAPTER

Telnet Server

Mode
GC
GC
GC
PE