Configuring Amac Address Filter - Edge-Core ECS4610-24F Management Manual

24-port layer 3 gigabit ethernet switch

Hide thumbs Also See for ECS4610-24F:

Table of Contents

ONFIGURING A

Figure 139: Configuring Link Detection for Network Access

Use the Security > MAC Authentication (Configure MAC Filter) page to

designate specific MAC addresses or MAC address ranges as exempt from

authentication. MAC addresses present in MAC Filter tables activated on a

port are treated as pre-authenticated on that port.

"Network Access (MAC Address Authentication)" on page 711

Specified MAC addresses are exempt from authentication.

Up to 65 filter tables can be defined.

There is no limitation on the number of entries used in a filter table.

These parameters are displayed in the web interface:

Filter ID – Adds a filter rule for the specified filter.

MAC Address – The filter rule will check ingress packets against the

entered MAC address or range of MAC addresses (as defined by the

MAC Address Mask).

MAC Address Mask – The filter rule will check for the range of MAC

addresses defined by the MAC bit mask. If you omit the mask, the

system will assign the default mask of an exact match.

(Range: 000000000000 - FFFFFFFFFFFF; Default: FFFFFFFFFFFF)

To add a MAC address filter for MAC authentication:

Click Security, Network Access.

Select Configure MAC Filter from the Step list.

Select Add from the Action list.

Network Access (MAC Address Authentication)

| Security Measures

Show Quick Links

Chapters

Table of Contents