Configuring Pim For Ipv4; Enabling Pim Globally; Configuring Pim Interface Settings - Edge-Core ECS4610-24F Management Manual

| Multicast Routing
C 21
HAPTER

Configuring PIM for IPv4

C PIM
ONFIGURING FOR
E PIM
NABLING
G
LOBALLY
C PIM
ONFIGURING
I S
NTERFACE ETTINGS
IP 4
V
This section describes how to configure PIM-DM and PIM-SM for IPv4.
Use the Routing Protocol > PIM > General page to enable IPv4 PIM routing
globally on the router.
CLI R
EFERENCES
"router pim" on page 1091
◆
C U
OMMAND SAGE
This feature enables PIM-DM and PIM-SM globally for the router. You
◆
also need to enable PIM-DM or PIM-SM for each interface that will
support multicast routing (see
necessary to the multicast protocol parameters.
◆ To use PIM, multicast routing must be enabled on the switch (see
"Enabling Multicast Routing Globally" on page
W I
EB NTERFACE
To enable PIM multicast routing:
Click Routing Protocol, PIM, General.
1.
Enable PIM Routing Protocol.
2.
Click Apply.
3.
Figure 364: Enabling PIM Multicast Routing
Use the Routing Protocol > PIM > Interface page configure the routing
protocol's functional attributes for each interface.
CLI R
EFERENCES
"PIM Commands" on page 1090
◆
C U
OMMAND SAGE
Most of the attributes on this page are common to both PIM-DM and
◆
PIM-SM. Select Dense or Sparse Mode to display the common
attributes, as well as those applicable to the selected mode.
– 548 –
page 548), and make any changes
544).