Configuring Global Settings For Snmp - Edge-Core ECS4610-24F Management Manual

| Basic Administration Protocols
C 14
HAPTER
Simple Network Management Protocol
C G
ONFIGURING LOBAL
S SNMP
ETTINGS FOR
C U
OMMAND SAGE
Configuring SNMPv1/2c Management Access
To configure SNMPv1 or v2c management access to the switch, follow
these steps:
Use the Administration > SNMP (Configure Global) page to enable
1.
SNMP on the switch, and to enable trap messages.
Use the Administration > SNMP (Configure User - Add Community)
2.
page to configure the community strings authorized for management
access.
Use the Administration > SNMP (Configure Trap) page to specify trap
3.
managers so that key events are reported by this switch to your
management station.
Configuring SNMPv3 Management Access
Use the Administration > SNMP (Configure Global) page to enable
1.
SNMP on the switch, and to enable trap messages.
Use the Administration > SNMP (Configure Trap) page to specify trap
2.
managers so that key events are reported by this switch to your
management station.
Use the Administration > SNMP (Configure Engine) page to change the
3.
local engine ID. If you want to change the default engine ID, it must be
changed before configuring other parameters.
Use the Administration > SNMP (Configure View) page to specify read
4.
and write access views for the switch MIB tree.
Use the Administration > SNMP (Configure User) page to configure
5.
SNMP user groups with the required security model (i.e., SNMP v1, v2c
or v3) and security level (i.e., authentication and privacy).
Use the Administration > SNMP (Configure Group) page to assign SNMP
6.
users to groups, along with their specific authentication and privacy
passwords.
Use the Administration > SNMP (Configure Global) page to enable SNMPv3
service for all management clients (i.e., versions 1, 2c, 3), and to enable
trap messages.
CLI R
EFERENCES
"snmp-server" on page 630
◆
"snmp-server enable traps" on page 633
◆
– 356 –